Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Cleaning, Care & Maintenance
•
Switch off and disconnect from the power supply before cleaning.
•
Clean the interior of the appliance as often as possible.
•
Do not use abrasive cleaning agents. These can leave harmful residues.
•
Always wipe dry after cleaning.
•
Agent or qualified technician must carry out repairs if required.
Cleaning the Condenser
Periodically cleaning the condenser can extend the life of the appliance. The condenser is located at the
of the appliance.
Note: Use a soft brush or vacuum cleaner to clean the fins of the condenser, taking care
not to damage the fins.
Troubleshooting
If your appliance develops a fault, please check the following table before making a call to the Helpline.
Fault
The appliance is not
The unit is not switched on
working
Plug and lead are damaged
Fuse in the plug has blown
Power supply
Internal wiring fault
The appliance turns
Condenser blocked with dust
on, but the
Doors are not shut properly
temperature is too
Appliance is located near a
high/low
heat source or air flow to the
condenser is being
interrupted
Ambient temperature is too
high
Insufficient airflow to the
fans
Appliance is overloaded
Factory default parameters
adjusted
The appliance is
The appliance is touching a
unusually loud
neighbouring object
The appliance has not been
installed in a level or stable
position
Probable Cause
Check the unit is plugged in correctly and switched on
Call agent or qualified Technician
Replace the fuse
Check power supply
Call agent or qualified Technician
Clean Condenser
Check doors are shut and seals are not damaged
Move the appliance to a more suitable location
Increase ventilation or move appliance to a cooler position
Remove any blockages to the fans
Reduce the amount stored in the appliance
Call agent or qualified Technician
Check installation position and change if necessary
Check installation position and change if necessary
3
Action
UK
Tabla de contenido
Solución de problemas
