Motor Cooling; General Cleaning - sunjoe 24V-HCS-LTE Manual Del Operador

Maintenance
Please contact an authorized Snow Joe
or call the Snow Joe + Sun Joe
®
at 1-866-SNOWJOE (1-866-766-9563) for all maintenance
operations not foreseen in this manual. Any operation
performed in an unauthorized service center or by unqualified
personnel will completely invalidate the warranty.
m
WARNING!
For your safety and that of others:
• Correct maintenance is essential to maintain the original
efficiency and safety of the machine over time.
• Keep all nuts, bolts, and screws tight to be sure the
equipment is in safe working condition.
• Never use the machine with worn or damaged parts.
Damaged parts are to be replaced and never repaired.
• Only use original Snow Joe
parts. Parts that are not of the same quality can seriously
damage the equipment, compromise safety, and invalidate
the warranty.
m
WARNING!
Always remove the battery before
performing any adjustments, maintenance, or repairs to your
cordless pruning saw.
• Use protective gloves when handling the bar and chain.
• Keep the bar encased in its sheath, except when working
directly on the bar or the chain.
• Never dispose of oils or other polluting materials in
unauthorized places.

Motor Cooling

To avoid overheating and damage to the motor, always keep
the ventilation slots clean and free of sawdust and debris.

General Cleaning

It's recommended to clean the pruning saw immediately after
each use for best performance. Use a cloth, a paintbrush
or a brush to remove dust and wood splinters. Always keep
the ventilation slots clean and free from obstructions. Clean
the housing of the pruning saw regularly with a damp cloth
and somewhat soft soap. Do not use any cleaning or solvent
materials. Make sure that no water or any other liquid can get
inside the cordless power tool.
Clean the sprocket area with a brush or compressed air
(Fig. 10).
+ Sun Joe dealer
® ®
customer service center
®
+ Sun Joe replacement
® ®
Replacing the Guide Bar and Chain
NOTE: When replacing the guide bar and chain, use only
identical replacement parts. Make sure the battery is not
inserted in the compartment before proceeding with operation.
m
WARNING!
Always wear heavy-duty gloves when
handling the bar and chain. Mount the bar and chain very
carefully so as not to impair the safety and efficiency of the
machine. If in doubt, contact an authorized Snow Joe
Sun Joe dealer or call the Snow Joe
®
service center at 1-866-SNOWJOE (1-866-766-9563).
m
WARNING!
The operation should be completed on a
flat and stable surface, with adequate space for moving the
machine and its components.
m
DANGER!
Never start the motor before installing the
guide bar, chain, and sprocket cover. Without all these parts in
place, the clutch can fly off or explode, exposing the user to
potentially serious injuries.
When you first purchase your pruning saw, the chain and bar
will come pre-assembled on the saw. Should you need to
replace the chain in the future, follow the steps below.
1. Screw the chain/sprocket end cover knob
counterclockwise to release chain/sprocket end cover
(Fig. 11).
Fig. 11
Chain/sprocket
end cover
End cover knob
14
Fig. 10
+
®
+ Sun Joe customer
® ®