SNOWJOE 323E Manual Del Operador página 11

Fig. 23
Belt
7. Replace the worn belt with a new belt, then screw the
motor support back into position (Fig. 24).
Fig. 24
8. Reattach the upper housing to the lower housing by
replacing all housing screws (Fig. 19).
9. Place the left side cover back into position and refasten
the five (5) screws.
10. Place the right side cover back into position and refasten
the five (5) screws.
Replacing the Scraper Blade
m
WARNING!
Disconnect the power from the electric
snow shovel before performing this task.
1. Turn the snow shovel over. Using a drill, remove the
four (4) screws that secure the scraper blade to the base
of the unit (Fig. 25).
Motor
support
Motor support
Belt
Fig. 25
4 screws
2. Remove the old scraper blade (Fig. 26).
Fig. 26
Scraper blade
3. Install the new scraper blade and fasten it securely to the
housing with the four (4) screws (Fig. 27).
Fig. 27
4 screws
Lubricating the Electric Snow Shovel
This electric snow shovel does not need lubrication. All
bearings are lubricated at the factory for the life of the product.
11
Drill
Scraper blade