Sensor Installation; Sensor Setup - BALDR B0389WST4H4-V3 Manual De Usuario

Powered by batteries:
1. Remove the battery compartment cover.
2. Insert 3x AAA battery matching the polarity(+and-).
3. Replace the battery cover.

SENSOR INSTALLATION

1. Remove the battery compartment cover.
2. Insert 2 x AA batteries in each sensor matching the polarity（+and-).
3. Replace the battery cover.

SENSOR SETUP

● Power the main unit prior to load the batteries of sensor.
● Switch the button of 3 sensors to CH1 , CH2 and CH3 ( the
channel of each sensor should be different from others).
Note: 1. Main unit will auto receive outdoor signal after power on,
the receiving status will last for max 3 minutes. The receiving
antenna signal will flash. If no signal received in 3 minutes, it
will stop receiving outdoor signal.
2. If the main unit is out of 3 minutes' signal receiving window,
you need to press and hold the "▲/CH" button to enter signal
receiving again.
MAIN UNIT SETUP
RF Signal Receiving
When power on or reset, the LCD will full display for 3 seconds with
"BI" sound,then enter into RF Signal Receiving.the main unit will
start receiving 3 outdoor sensors' signal for 3 minutes. After all 3
channels signal received within 3 minutes or receiving window
ends,please do the Manual Settings.
6