Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installing the Transmitter Batteries
Turning on the power
Turn on transmitter first and then turn on receiver.
Turn on the transmitter switch and the LED battery
indicator will light up.
Turn on the receiver. The automatic set-up of the factory
set speed control should have been completed. If you
experience any problems with the speed control settings
refer to the Electronic Speed Control Section for correct
setup information.
Turning off the power
Turn off receiver first and then turn off transmitter.
If you switch off the transmitter first before the R/C car, you may lose control of the R/C car.
•
Turn off the receiver switch.
•
Turn off the transmitter switch.
•
Disconnect the battery connector from the speed control connector.
Binding the Transmitter and Receiver
You may need to setup your transmitter to 'bind' with the receiver if you change to a new receiver or for any reason
lose signal.
•
Place the transmitter and the receiver close to each other (within one meter).
•
Turn the power switch on the transmitter to the ON position.
•
Press and hold the receiver setup button, then turn the power switch to the ON position.
•
The receiver LED will flash quickly. Release the setup button after 1 second.
•
Press and hold the binding button on the transmitter for 1 second until the LED on the
receiver is continuously lit.
Fail Safe Setup
Caution
Any new binding of transmitter & receiver will clear the pre-set fail safe.
•
With the transmitter and car switched on, press the setup button on the receiver then release. LED will flash.
Electric setup
•
Leave throttle trigger in neutral position, and press the setup button. The LED will flash quickly. Once the
receiver LED remains lit, then release the setup button on the receiver.
Nitro setup
•
Hold full brake on the transmitter, and press the setup button. The LED will flash quickly. Release full brake on
the transmitter once the receiver LED remains lit, then release the setup button on the receiver.
Open the battery holding
tray to expose the empty
battery slots.
Insert 4 AA batteries
into the marked spaces.
Please note the correct
direction of the batteries
Power LED
3
Incorrect battery insertion
could damage the transmitter
2.4Ghz technology has done
away with the need for long
extendable aerials. The Aerial
on your transmitter is located
internally
The Red LED will show if the
installed AA batteries have
sufficient charge.
The Red LED will flash and
there will be an audible beep if
the batteries need replacing.
Tabla de contenido
