Tabla de contenido
Idiomas disponibles
Idiomas disponibles
*TV700 / 386237
12/8/03
Motor
Be sure your power supply agrees with nameplate marking.
120 volts, AC only means your tool may be operated only with alternating
current and never with direct current.
Voltage decrease of more than 10% will cause loss of power and overheating.
All tools are factory tested; if this tool does not operate, check the power supply.
ASSEMBLY/ADJUSTMENT SET-UP
WARNING:
Always unplug sander from power supply before any of the
following operations.
•TO ATTACH 1/4 SHEET SANDPAPER
•
Lift clamps up with your thumb, (Fig. 1). Rotate the clamp lever downward
until the clamp is fully opened.
•
Lay sandpaper on a flat surface and, centering the pad of the unit, press the
sander down firmly onto the paper.
•
Wrap ends of the sandpaper around ends of the sander pad and clamp
them in place using the clamps.
•
To close clamps, rotate clamp handles back up as far as they will go and
lock them in place. Stretch sandpaper as tight as possible when clamping.
•
NOTE: On new tools the sandpaper may be difficult to install because of the
stiffness of the sanding pad. This condition will improve as the pad
compresses over time.
OPERATING INSTRUCTIONS
=
WARNING
:
To reduce the risk of serious personal injury, read, understand
and follow all important safety warnings and instructions prior
to using tool.
•SWITCH
To turn the tool on, hold it, as shown in Fig. 2, and push the portion of the switch
marked "I". To turn the tool off, push the portion of the switch marked "O".
All manuals and user guides at all-guides.com
10:22 AM
Page 5
•OPERATION
Grasp sander, as shown in Figure 3, and turn it on. Move it in long, sweeping
strokes along the surface, letting it do the work. Pushing down on the tool while
sanding actually slows the removal rate and produces an inferior quality finish.
• Check your work often. Sander is capable of removing material rapidly,
especially with coarse paper.
MAINTENANCE
Use only mild soap and damp cloth to clean the tool. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
IMPORTANT: To assure product SAFETY and RELIABILITY, repairs, maintenance
and adjustment should be performed by authorized service centers or other
qualified service organizations, always using identical replacement parts.
Lubrication
MASTER MECHANIC tools are properly lubricated at the factory and are ready
for use.
ACCESSORIES
Accessories
A full array of accessories for use with your tool are available from your local
dealer or authorized service center.
CAUTION: The use of any accessory or attachment not recommended may be
hazardous.
Two Year Quality Guarantee
This product is warranted for two years against any defects in material and
workmanship. If defective, the product will be repaired or replaced free of
charge. Simply provide proof of purchase and return the tool to your place of
purchase. Normal wear or damage due to abuse, mishandling or unauthorized
repair is not covered. This warranty does not apply to accessories. This warranty
gives you specific legal rights and you may have other rights which vary from
state to state.
5
Tabla de contenido
