Promax SATHUNTER+ Guía Rápida De Utilización página 8

SATHUNTER+
"LOW BATTERY"
"VERY LOW BATTERY"
"LNB SHORT CIRCUIT"
"LNB OVER CURRENT"
"MANUAL POWER OFF"
"AUTO POWER OFF"
"SERVICE MODE"
"BATTERY MODE"
"UPDATE MODE"
"NETWORK NOT FOUND"
"SERVICES NOT FOUND"
"LNB NOT DETECTED"
"FULL BATTERY"
"MPEG-2 NOT DETECTED"
"LOADING NETWORK"
"LOADING SERVICES"
"HIGH TEMPERATURE"
At right top corner, next to the messages, the following icons may appear.
Icon
18/13/OFF
,
,
USB
- 0 DG0078 -
Message
or
or
Description
-
The equipment will be switched off automatically.
The LNB can be short circuit.
The LNB has a high consumption.
The instrument has to be switched off by hand.
The instrument will switched off after five minutes of
inactivity.
-
-
-
-
-
Power level is below the minimum necessary to detect a LNB
(this value can be adjusted by software, usually 10 %).
-
It is not detecting the Transport Stream signal MPEG-2.
-
-
The running temperature is too high. The equipment must
be switched off for a while. If the problem persists, contact
with the technical support.
Description
Charging battery.
Battery state.
LNB power supply. ( 13 V, 18 V or OFF).
22 KHz signal activated.
The DVB-S, DVB-S2 or DSS has not been
synchronized.
The DVB-S, DVB-S2 or DSS has been
synchronized.
Manual Power Off.
USB connected to the PC.
P.8