Technical Data - Skil 3155 Manual Original

a
Cordless LED light
INTRODUCTION
• The worklight is intended for
illumination in dry indoor areas
• This tool is not intended for
professional use
• Read this instruction manual carefully
before use and save it for future
reference 3

TECHNICAL DATA 1

Dimensions (length x width x height): 110
x 63 x 180 mm
TOOL ELEMENTS 2
A On/off switch
B Lamp head
C Battery level indicator
SAFETY
GENERAL
• Handle the worklight with care
• Do not direct the light beam at
persons or animals and do not
stare into the light beam yourself
(not even from a distance)
• Do not cover off the lamp head
while operating the worklight
(the lamp head heats up during
operation and can cause burns
when the heat accumulates)
BATTERIES
• The battery supplied is partially
charged (to ensure full capacity of the
battery, completely charge the battery
in the battery charger before using
your power tool for the first time)
• Only use the following batteries
and chargers with this tool
- SKIL battery: BR1*31****
- SKIL charger: CR1*31****
• Do not use battery when damaged; it
should be replaced immediately
• Do not disassemble the battery
• Do not expose tool/battery to rain
• Permitted ambient temperature (tool/
charger/battery):
- when charging 4...40°C
- during operation –20...+50°C
3155
- during storage –20...+50°C
EXPLANATION OF SYMBOLS ON
TOOL/BATTERY
3 Read the instruction manual before
use
4 Batteries may explode when disposed
of in fire, so do not burn battery for
any reason
5 Store tool/charger/battery in locations
where temperature will not exceed
50°C
6 Do not dispose of electric tools and
batteries together with household
waste material
7 Insulation class III
USE
• Charging battery
! read the safety warnings and
instructions provided with the
charger
• Removing/installing the battery 2
• Battery level indicator 8
- press the battery level indicator
button D to show the current battery
level.
• Operating the tool 9
- press switch A once to turn on the
light in high brightness mode
- press switch A again to select low
brightness mode
- press switch A again to turn off
the light
• Adjusting the lamp head q
- the lamp head B pivots 120 degrees
- manually move the head to any
position
! do not force the head beyond
120 degrees
• Battery protection
Switches off the tool or prevents the
tool from being switched on, when
- the battery temperature is not within
the allowable operating temperature
range of -20 to +50°C
- the lithium-ion battery is nearly
empty (to protect against deep
discharge)
5