savic Dog Barrier Door Manual De Instrucciones página 2

2
Important: keep for future reference
Introduction
Please take a few minutes to read your instructions fully to ensure the full
safety benefit of your Dog Barrier door.
Check that you have all the contents as per the list.
A) 1 Dog Barrier door
B) 4 screw adjusters
C) 4 locking rings
D) Bag containing 2 screws (D1), 2 wall cups (D2), 2 wall sticky pads (D3)
and 2 plugs (D4).
If any component parts are missing or damaged do not use your gate.
Where to fix your Dog Barrier door?
Your gate is ideal for restricting access to any room in your home from
kitchens to bedrooms and may be used to span hallways, doorways or
appropriate stairways. Check the width of the opening in which you intend
to fit your Dog Barrier door. The smallest opening is 75 cm and the largest
opening is 84 cm. Important: Do not attempt to use this gate in openings
larger than 84 cm. For openings greater than 84 cm, 7 cm extensions
(Art. nr. 951097) are available. Due to the nature of the pressure fit fixing
method this gate must be used in a strong and secure opening. Ensure all
surfaces are clean and free of loose materials.
Notes on staircase positioning
Warning: The position of your safety barrier in relation to the stairs is very
important for your pet's safety. Your gate may be better positioned across
your landing to prevent access to the stairs completely. If you do require
your gate to be positioned at the top of the stairs to prevent your dog
descending, the gate must be fitted on the very top stair. When descending
the stairs, the door should always open towards you (away from the stairs).
If you intend to use the gate at the bottom of the stairs then it must be
placed on the lowest stair, towards the front of the step, away from the
2nd step. When passing through a gate at the top of a staircase, particular
attention should be paid to the bottom bar of the U shaped frame to avoid
tripping.
Fixing your Dog Barrier door and wall cups
Please refer to the pictures. Slide the 4 screw adjusters (B) into the plastic
bungs at each corner of your gate. Your gate must be fitted with wall cups
(D2), these should be placed around the top 2 screw adjusters (B). Place the
gate into the required opening, in the closed position. To ensure that you
secure the gate correctly, begin with the screw adjusters (B) at the bottom
of the gate. Ensure that your gate is central, slide out the adjusters (B) and
(2)
D2
D1
B C D
75c m M I N
81c m M A X
137cm M A X ( w i t h e x te n s i on s )
(1)
D3
D4
1
2