Car-O-Liner CMI 300 PULSE Guía De Usuario página 14

Connection and start-up
Adjustment of wire brake
The wire brake must be adjusted so as to stop the wire reel before
the welding wire runs over the edge of the reel. The brake force
depends on the weight of the wire reel and the wire feed speed.
Factory setting is:
15 kg (CMI 300 Pulse/CMI 300 Pulse Twin) or
5 kg (CMI 300 Pulse Trio).
Adjustment:
• Dismount the control knob
by placing a thin screw driver
behind the knob and then
pull it out.
• Adjust the wire brake by
fastening or loosening the
self-locking nut on the axle of
the wire hub.
• Remount the control knob
Adjustment:
• Adjust the wire brake by
fastening or loosening the self-
locking nut on the axle of the
wire hub.
Assembly of parts in wire feed unit
All manuals and user guides at all-guides.com
Adjusting the 15 kg wire brake
Adjusting the 5 kg wire brake
14
Software update
• Insert the SD-card
• Turn on the machine
• Wait until the unit
indicates that the update
is complete
• Turn off the machine and
remove the SD card
• The machine is now ready for use
New software will be loaded into power source and all
connected units.
x4
Adjust the pressure of
the thumbscrew so that
the wire feed rolls run
smoothly on the wire
when it is stopped at the
contact tip