Mansfield Dual-Drill DD18 Manual De Operación Del Usuario página 4

Warning:If any parts are missing, do not
!
operate tool until the missing parts are
replaced. Failure to do so could result in
possible serious personal injury.
DISPOSAL OF EXHAUSTED BATTERY
Warning: Do not attempt to dissemble
!
the battery pack. Fire or injury may result.
For safety and to preserve natural resources, please recycle or
dispose of properly. This product Contains Nickel-Cadmium Battery.
Must be disposed off properly. Local, state, or federal laws may
prohibit disposal of Nickel-Cadmium batteries in ordinary trash.
Consult your local waste authority for information regarding available
and/or disposal options.
BATTERY PACK PREPERATION FOR
RECYCLING
Warning: Upon removal, cover the
!
battery pack's terminals with heavy duty
adhesive tape. Do not attempt to destroy
or dissemble the battery pack or remove
any of its components. Do not touch both
terminals with metal objects and body
parts, as short-circuit may result. Keep
away from children. Failure to comply with
these warnings could result in fi re and/or
serious injury.
Warning: Before attempting to use any tool,
!
make sure you are familiar with all operation
features and safety requirements.
5
4
3
1
Discription
1.
Tricker with variable speed
2. switch for right/left-running
3. keyless chucks
4. revolving head
5. head release knobs
6. torque-adjustment
7. accu locking and release switch
8. accu-pack
6
2
7
8
Battery Charging
To charge the battery pack it
must fi rst be removed from the
drill. To remove the battery pack,
press the battery release knobs
at each side of the battery as
shown at illustration. Now gently
pull the battery pack from the
housing.
Rapid charger
Note: To increase the lifetime of
the battery, always empty and
fully charge it every time.
Gently plug the battery into
the charger. Connect the plug
to an AC power outlet. Then
press the "SET" button.
The green indicator light will turn on if the battery is inserted
correctly. Press set button to begin charging. Depending on the
loading condition the battery will be fully charged after approx.
60-70 minutes. As soon as the battery is completely charged,
the charger will fi nish the charging process automatically.
!
NOTE: it is only the chuck pointing forward that is connected to the
motor and can have installed or removed bits
Installing and removing bits
This DualDrill is fi tted with 2
keyless chucks which mean
that no chuck key is required to
secure the drill and screw bits.
Place the drill bit into the chuck
as far as it will go, then hand
tighten. Alternatively grip the
black front part of the chuck and
slowly run the drill clockwise until
the chuck grips the bits fi rmly.
Rotating the dual head
To rotate the dual head place
the direction knob in center
position and remove your fi ngers
from the trigger. Then grip the 2
release knobs with 2 fi ngers and
press them backwards approx.
6mm. Then turn the head. When
turning the head you can release
the release knobs. They will
automatically lock the dual head
when it is placed in position.
3
Warning: Before installing or removing bits,
place the direction switch in center position.
This will turn off the power to the drill.