Tabla de contenido
Idiomas disponibles
Idiomas disponibles
•
Always unplug the unit before servicing it in any way.
•
The temperature of the water remaining in the unit after use may be HIGH.
•
Do not submerse the unit in water, or allow water to enter the inside of the unit or humidity
spout. Only put water into the water tank.
iNSiDE tHE BoDY oF tHE UNit
Pour excess water out of the unit, but do not allow it to enter the humidity spout. Wash
out the unit with fresh water, using the cleaning brush and a soft cloth as needed.
oUtEr SUrFacE oF tHE UNit
Wipe the surface of the unit with a soft, damp cloth if needed.
WatEr taNk
If water spots remain in the water tank, wipe the inside with a soft cloth.
DO NOT use soap or detergents.
ULtraSoNic DiSk
Remove water tank (Fig. 1) and use the enclosed cleaning brush to regularly remove build up
and deposits from this area (Fig. 2). Diluted white vinegar will help to prevent this build up.
Fig. 2
Fig. 1
•
Fully dry the inside and outside of the unit before storing it.
•
DO NOT leave water in the unit.
•
Store in a cool, dry place.
E-6
H1600_0509_Manual.indd 4
ProBLEM
SoLUtioN
Water mist and humidity
Power Plug: Unplug and then try again.
are not produced.
Power Failure: When the power is returned, try again.
Water Tank Installation: Make sure the water tank is
correctly attached. Make sure spring on tank
cap moves freely when pushed.
Air blows but water mist
Excessive Water: Remove water tank. Empty a
small amount of water from the base of the unit.
is not produced.
The desired humidity is lower than the current
temperature: Increase the desired humidity.
Detergent residue in the tank: Wash the tank out
and try again.
The surface of the ultrasonic disk is dirty. Clean
with white vinegar.
Humidity level is low.
The water in the unit is too cold: Replace with cool,
but not cold water.
If ultrasonic disk is damaged contact
customer Service at 1.866.603.5900.
Warm humidity is not produced.
It may take 10-15 minutes before warm
humidity is created. The mist may not feel
warm to the touch.
Check to see if base of unit feels warm to the touch.
If so then warm mist is being produced.
The humidity has a bad smell.
Poor maintenance or dirty water: Clean the product
thoroughly, and fill it with fresh water.
White dust is forming on
Hard water will deposit a certain amount of
nearby furniture.
dust. Dust in the air settles because of the
added humidity in the room.
*Use distilled water if this becomes a nuisance.
E-7
5/18/2009 11:57:43 AM
Tabla de contenido
