EAS ELECTRIC WLL Serie Manual De Instalación Y Manual De Usuario página 33

13. Maintenance
Caution
• Please release pressure before disassembly.
• Before you clean the air conditioner, ensure it is powered off.
• Check that the wiring is undamaged and connected.
• Use a dry cloth to wipe the indoor unit and remote controller.
• A wet cloth may be used to clean the indoor unit if it is very
dirty.
• Never use a damp cloth on the remote controller.
• Do not use a chemically treated duster on the unit or leave this
type of material on the unit to avoid damaging the finish.
• Do not use benzene, thinner, polishing powder, or similar
solvents for cleaning. These may cause the plastic surface to
crack or warp.

Method for cleaning the air filter
a. The air filter can prevent the dust or other particles from
entering the unit. If the filter is blocked, the unit will not work
well. Clean the filter every two weeks when you use it regularly.
b. If the air conditioner is positioned in a dusty place, clean the
filter often.
c. Replace the filter if it is too dusty to clean (the replaceable air
filter is an optional fitting).
1. Open the unit
Open the unit by placing your fingers under the notches on the sides
of the cover and moving the cover outwards. Open the cover fully to
allow sufficient room to remove the filter.
Figure 13.1
2. Dismantle the filter
Gently push the filter upwards to release the notches, then pull the
filter out.
Figure 13.2
3. Clean the air filter

Dusts will accumulate on the filter along with the unit operation,
and need to be removed from the filter,or the unit would not
function effectively.

Clean the filter every two weeks when you use the unit regularly.
 Clean the air filter with a vacuum cleaner or water.
a. The air intake side should face up when using a vacuum
cleaner. (Refer to Figure 13.3)
b. The air intake side should face down when using clean water.
(Refer to Figure 13.4)

For excessive dusts, use a soft brush and natural detergent to
clean it and dry in a cool place.
Caution
• Do not dry out the air filter under direct sunshine or with fire.
• The air filter should be installed before the unit body
installation.
4. Re-install the air filter.
5. Install and close the air inlet grille by reversing steps 1 and 2.
 Maintenance before stopping using the unit for a long time
(e.g., at the end of a season)
a. Let the indoor units run in fan only mode for about half a day to
dry the interior of the unit.
b. Clean the air filter and indoor unit casing.
c. Refer to "Cleaning the air filter" for details. Install cleaned air
filters back in their original positions.
d. Turn off the unit with the ON/OFF button on the remote
controller, and then unplug it.
Caution
• When the power switch is connected, some energy will be
consumed even if the unit is not running. Disconnect the
power to save energy.
• A degree of dirt will accumulate when the unit has been used
several times, which will require cleaning.
• Take of the batteries from the remote controller.
Maintenance after a long period of non-use

a. Check for and remove anything that might be blocking the
inlet and outlet vents of the indoor units and outdoor units.
b. Clean the unit casing and clean the filter. Refer to [Cleaning
the filter] and "Cleaning the filter" for instructions. Re-install
the filter before running the unit.
c. Turn on the power at least 12 hours before you want to use
the unit to ensure it works properly. As soon as the power is
turned on, the remote control display appears.
13
Figure 13.3
Figure 13.4
V.1