Care And Cleaning - Kohler STERLING 442121 Guia De Instalacion

Install the Lavatory (cont.)
NOTE: You can also use other fastening devices of sufficient size
and strength.
Install the hanger bolts to the backing material. Thread the cap
nuts onto the two hanger bolts. Use a 9/16" wrench to thread the
hanger bolts into the wall so 1" (2.5 cm) of each bolt remains
exposed between the cap nuts and finished wall.
Remove the cap nuts.
Install the faucet and drain to the lavatory according to the
manufacturer's instructions.
Move the pedestal and lavatory back into position and fit the
lavatory over the hanger bolts. Make sure the lavatory rests
directly on the pedestal and fits flat against the wall.
Remove the lavatory and set it aside.
CAUTION: Risk of product damage. Do not overtighten or
damage may occur.
Thread a washer and lag bolt through the pedestal hole and into
the floor until the washer contacts the pedestal. Tighten the lag
bolt until snug.
Move the lavatory back into position over the hanger bolts.
Double check the installation to be sure it is level and properly
positioned.
Install washers and cap nuts to the hanger bolts and tighten until
the washers contact the lavatory. Tighten the cap nuts until snug.
Connect and tighten the trap to the drain.
Complete the water supply connections to the faucet according to
the instructions packed with the faucet.
Clean up with a nonabrasive cleaner.

Care and Cleaning

For best results, keep the following in mind when caring for your
Sterling product:
• Use a mild detergent such as liquid dishwashing soap and warm
water for cleaning. Do not use abrasive cleaners that may scratch
or dull the surface.
• Carefully read the cleaner product label to ensure the cleaner is
safe for use on the material.
1019859-2-B 6 Sterling