LF Allen + Roth EASTVIEW LP8074DLAZ Manual Del Usuario página 7

ASSEMBLY INSTRUCTIONS
4. Thread the downrod (C) into downrod support
of the motor assembly (A). Align the holes in
the downrod support of the motor assembly (A)
with the holes in the downrod (C) and install the
previously removed clevis pin. Secure clevis
pin with previously removed hairpin clip.
Tighten the two set screws in the downrod
support of the motor assembly (A).
WARNING
It is critical the clevis pin in the downrod support
is properly installed and the set screws are
securely tightened. Failure to do so could result
in the fan falling.
5. Route wires through motor coupling cover
(F), canopy screw cover (E) and ceiling
canopy (D).
Note: The keyslots of the canopy screw cover (E)
should be toward the ceiling direction.
6. Reinstall the hanger ball on the downrod (C)
by routing the three 54 in. wires from the motor
assembly (A) through the hanger ball. Position
the pin removed in step 1 through the two
holes in the downrod (C) and align the hanger
ball so the pin is captured in the groove in the
top of the hanger ball. Pull the hanger ball up
tight against the pin. Securely tighten the
preassembled set screw in the hanger ball.
CAUTION
A loose set screw could result in a wobbly fan.
4
A
5
D
6
7
C
Lowes.com/allenandroth
C
E
F