Air Conditioner Operations And Performance - EAS ELECTRIC CST4 Serie Manual De Instalación Y Manual De Usuario

Table: Display panel output under normal operating conditions.
Unit state
Standby
Shutting-down
Normal operation
Operation
Cold draft prevention
or outdoor unit
defrosting operation
A timer has been set

11. Air Conditioner Operations and Performance

The operating temperature range under which the unit runs stably are given in
below table.
M o d e n I
Cooling If the indoor humidity is above 80%, condensation
may form on the surface of the unit.
Heating
Caution
• The unit performs stably in the temperature range given in above table.
If the indoor temperature is outside the unit's normal operating range, it
may stop running and display an error code.
To ensure the desired temperature is achieve defficiently, ensure that:

All windows and door are closed.

The airflow direction is adjusted to work in running mode.
The air filter is clean.
Please note how you can best save energy and achieve the best cooling/heat-
ing effect.

Regularly clean air filters inside indoor units.
Check
regularly
Digital display
Timer
indicator
Unit state
Operation indicator
flashes slowly
All indicators off
Operation indicator
on
Operation and
Anti-cold / defrosting
indicators on
Timer indicator on
d o r o e t m p e a r u t e r
17-32°C
≤ 27°C
Figure 11.1
Infrared signal
receiving window
Anti-cold air /
defrosting indicator
Figure 10.2
Display output
Digital display panels
Digital display
Cooling and heating modes: set temperature
Fan only mode: indoor ambient temperature
Set temperature
Avoid too much outdoor air coming into air-conditioned spaces.

Note that outlet air is cooler or heater than set room temperature. Avoid

direct exposure to outlet air as it may be too cool or hot.
Maintain a proper air distribution. Air outlet louvers should be used to adjust

the direction of outlet airflow, as doing so might ensure more efficient
operation.
16
ALARM
Operation
indicator
Close doors and windows.
Figure 11.2
Do not set the
temperature too
low
Figure 11.3
V.1