Cequent Performance Products 76143 Instrucciones De Instalación página 7

3h. Remove fascia – Using a plastic trim panel tool, remove the fascia
starting at the outer edges near wheel wells, and gently pulling the
fascia.
4. Remove bumper beam – using a 15mm socket, remove (8) flange nuts,
(4) per side. Remove the bumper beam and return to vehicle owner.
© 2017 Cequent™ Performance Products, Inc. -
Printed in Mexico
3i. Remove fascia – Disconnect the (2) wiring harnesses and set fascia aside.
5. Trim fascia - using a tape measure, marker, and utility knife, cut a notch in
the lower part of the fascia underbody panel approximately 3-1/2" wide x
2-1/2" deep, centered on vehicle as shown. See Figure 2.
3-1/2"
Figure 2
Sheet 7 of 24 76143NP
Optional trim
C L
this line
2-1/2"
4-4-17 Rev. A