Care And Maintenance - Bar Maid BLE-300 Manual De Instrucciones

CArE AND MAINTENANCE

CLEANINg
Do not put the container assembly & blender base assembly in the dishwasher.
1.
Before first use and after every use, separate container parts from the base.
2.
Add cleaning solution to the container. Use water (less than 115°F/46°C) and a non-sudsing detergent.
3. Scrub and flush out the container interior lid and feeder cap to remove food residue.
4.
Fill container ¼ full with fresh washing solution and place it on the base.
5. Replace the lid on the container and run the blender on high speed for 2 minutes.
6. Repeat step 5 using clean rinse water.
7.
Wipe down the container, feeder cap, and lid with a soft cloth or sponge.
8. Wipe the exterior of the base with a damp cloth or sponge then dry thoroughly. The base contains
electrical components: do not immerse, use a high-pressure washer, or use a dishwasher to clean
the base.
9. Wipe any excess food particles from the power cord.
CARINg TIPs
To care for your blender, please read the tips as follows:
1. Periodically check all parts before reassembly, as use of damaged or non-recommended parts could
result in a severe personal injury and/or damage to the blender.
2. Blades: If the processing blades are stuck or difficult to turn, DO NOT USE BLENDER. Unplug the blender.
Check the blades by carefully turning in a counterclockwise direction, where the opposite edges are
sharp. Blades should turn freely.
3. Container: If the Eastman Tritan™ Container is cracked, DO NOT USE BLENDER, further use could result
in the container breakage during use.
4.
Blender Base: Never immerse the blender base in water. Unplug unit. The housing can be cleaned with
a damp cloth.
5.
Motor: The motor is permanently lubricated and does not require any additional lubrication.
MAINTENANCE
Inspect the blender and its various parts and replace as follows:
DAILY
1.
Unplug the blender and remove the container from the base.
2. Inspect the container blades for wear, nicks, and broken or loose blades. Replace if necessary.
WEEKLY
1. Unplug the blender.
2. Inspect the power cord insulation and power plug for cracks.
QUARTERLY
1. Review the condition of the container assembly at least every 90 days.
2.
Replace if necessary.
REPLACEMENT PARTS
For replacement parts call 954-960-1468.
Bar Maid Model BLE-300 Commercial Blender
|
7