Safety Instructions - EGAmaster 79632 Manual De Instrucciones

Any tool can be dangerous.
Please follow these simple procedures.
They are for your protection.
Remove rings, watches, ties etc. that could be torn by the machine.
Dress properly. Do not wear loose clothing or jewellery, it can be caught in moving parts.
Follow the general current and appropriate Accident Prevention and Safety Procedures.
Never work under the influence of alcohol, drugs or stronger medication.
Secure the working place well. Use clamps or a vice to fix the work piece.
Keep your working area clean and uncluttered.
Keep children away and avoid other persons to come into contact with the machine.
Switch off the machine if it stops - for any reason - to avoid the unexpected starting in uncontrolled
condition.
Do not operate the tool if it is damaged, improperly adjusted or not completely and correctly
assembled.
Check air hose for damage.
Work with oleiferous air only.
Do not employ machines by excessive force. Their performance is better and safer, if they work at
the prescribed speed.
Check damaged parts.
Before using the machine, damaged parts or protective devices should be carefully checked to
make sure they work soundly and fulfil the designated function. Check alignment, connections and
attachment of moving parts. Also check if parts are broken. Parts or protective devices that are
damaged should, if nothing else is mentioned in these operating instructions, only be exchanged
or repaired by qualified personnel. The same applies to defective switches and valve triggers. If the
machine cannot be switched on or off with the valve trigger, it should not be used.
The use of other accessories, or other additional items than recommended in these operating
instructions, may include the risk of bodily injury.
Only operate the tool after a thorough training or under supervision of a trainer.
Never exceed the maximum operation pressure.
Follow the valid national provisions in the country of application.
Secure the unit with the safety chain before drilling.
Never use blunt cutters.
Always disconnect air when changing cutters or working on the machine.
ATTENTION! Never use the flexible hose as a lifting handle!

SAFETY INSTRUCTIONS

Wear goggles ( chips – risk of injury)
Wear gloves (cutting damages by sharp edged work pieces)
Wear protective clothing
Wear safety shoes
27