Designers Edge L1306 Instrucciones De Operación página 4

TRIPOD ASSEMBLY INSTRUCTIONS (ONLY
SELECT MODELS COME WITH A TRIPOD)
1. To assemble the tripod models, begin by loosening the black adjustment knobs on the tripod
legs. Slide the center pole through the adjustment sleeve and into bottom pole receiver. Tighten
receiver bolt so pole receiver is secure to pole. Tighten adjustment knob so legs stay fixed in
place. Now you are ready to install top portion of fixture (See Figure 1).
2. Next mount the handle to the sled base with the screws/knobs included. (See Figure 2).
3. Tighten adjustments knob on sides of work light heads so yoke is in upright position. Position
center hole in yoke over hole in crossbar. From underside of crossbar slide black bolt through hole
in yoke. Tighten screw/knob to secure yoke to crossbar. Repeat process for second work light if
your model has twin heads. (See Figure 3).
4. Position center hole of sled base over top hole on tripod and screw with knob (See Figure 4).
5. Lamp height can be adjusted by loosening the compression nut, sliding pole to desired height
and retightening the nut (See Figure 5).
YOUR NEW FIXTURE IS NOW READY TO OPERATE. PLEASE PROCEED TO THE OPERATING
INSTRUCTIONS SPECIFIC TO YOUR UNIT TYPE, WHICH WILL EITHER BE 120V OR RECHARGEABLE.
PLEASE READ OPERATING INSTRUCTIONS THOROUGHLY BEFORE YOU BEGIN USE. DO NOT
OPERATE WITHOUT SAFETY GLASS INSTALLED ON WORKLIGHT HEAD!
OPERATING INSTRUCTIONS FOR
120 VOLT UNITS
• Plug into wall outlet.
• Press on/off switch on the rear of the unit to operate.
IMPORTANT NOTES FOR 120 VOLT UNITS:
• Do not immerse in water or other liquid.
• Do not use abrasive cleaners. Clean with a damp cloth.
• Do not operate the unit under extreme temperatures
and/or high humidity.
• Keep away from direct sunlight.
TROUBLE SHOOTING FOR 120 VOLT UNITS
If light does not work check the following:
1. Be sure you have power at the source.
2. Make sure fixture is properly plugged into the power source.