Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Terminal
+ -
ALARM YEL GRN
TAMPER +-
AM +-
LED ENABLE
SET / UNSET
NOTE: Make sure that jumper J5 is installed to bypass the Swivel Tamper.
Step 5b: Setting DIP Switch Settings (Standalone Mode)
Set the DIP switch settings according to the table, below:
DIP
Description
SW
1*
LEDs: ON: Enable / OFF: Disable
2*
Sensitivity (PIR)
3*
4*
Anti Masking: ON: Enable / OFF: Disable
5*
High Sensitivity (Anti Mask): ON: High /OFF: Low
6
Mode: ON: BUS / OFF: Relay (see Defining BUS ID)
Relay mode
Normal
DEOL
TEOL
NOTES:
1. For DEOL DIP switches 7 and 8 should both be ON.
2. For TEOL DIP switch 7-10 should be ON.
Adjust microwave coverage area by using the trimmer on the PCB.
MIN MAX
Description
+12 VDC, - GND
N.C alarm relay
NOTE: As defined by DIP SW 6
N.C tamper switch
N.C anti mask alarm relay
Used to remotely control the LEDs when DIP1 is set to ON
Enable: input is +12V OR no terminal connection
Disable: Connect the input to 0V
This feature prevents an intruder from gaining knowledge of the
detector's status and disables anti-mask detection.
This input enables controlling anti-masking operation in accordance to the
system status, Set (Arm) / Unset (Disarm).
System Status
Set (Arm)
Unset (Disarm)
* DIP SW 4 is ON (Anti mask enabled)
Low
Mid.
OFF
OFF
OFF
ON
DIP SW 7
OFF
ON
ON
YEL / GRN (RISCO BUS)
Input Status
0V
12V or no connection
Norm.
Max.
ON
ON
OFF
ON
DIP SW 8
DIP SW 9
OFF
OFF
ON
OFF
ON
ON
4
AM Relay
Off
On*
Def.
Def. Status
ON
LEDs ON
ON
Normal
OFF
ON
Enable
OFF
Low
OFF
Relay
DIP SW 10
OFF
OFF
ON
Tabla de contenido
