Troubleshooting - Aigostar 8433325504274 Manual Del Usario

145*210MM/莫思妮,16156000A25922 MY-GD20D4W__310100JHJ 说明书/YDX,20170622

Troubleshooting

Phenomenon
The product does not
work after power-on.
The product works but
does not produce any
steam after power-on.
The Ironing head drips
water.
Water leak.
The steam is blocked.
In operation, there is a
"grunt" sound.
In addition to the hot
head, the steam
occurs in other parts
The remote controller
cannot be used (only
for the existing model
of the remote
controller).
The gear light flashes
after start.
WARRANTY: 2 YEARS
Cause
The power plug is not inserted.
The domestic circuit fails or the
fuse is burnt.
The product circuit fails.
The water tank does not have any
water or too little water.
The internal steam channel is bent
or disengaged.
The heating plate is damaged.
The indicator light illuminates, but
does not produce any steam.
The steam is condensed, which is
a normal phenomenon.
The heating plate is damaged.
There is much water scale on the
heating plate.
The product is placed on a high
table, for example, on a table or a
chair.
Water overflows from the
connection between the water tank
and the main machine.
The steam conduit is bent.
When the steam conduit is in the
U-shaped state, the steam
condenses in the steam conduit.
The product is placed on a high
table, for example, on a table or a
chair.
·
The steam conduit is not
installed in place.
.
·
The sealing part is damaged.
The remote controller cannot be
.
used
Too high or too low voltage
protection.
Troubleshooting
Insert the power plug.
Please contact the professionals for
inspection and repair.
Please contact the professionals for
inspection and repair.
Fill the water tank.
Please contact the professionals for
inspection and repair.
Please contact the professionals for
inspection and repair.
Please contact the professionals for
inspection and repair.
In use, lift the hot head and vertically
straighten the steam conduit, and
shake the hot head.
Please contact the professionals for
inspection and repair.
Shut down, and clean the water scale
in the heating plate.
Place the product on the ground.
·
Remove the steam return pipe
and straighten the bent section.
·
Remove water scale in the
heating plate.
After installing the steam conduit,
start, wear gloves, hold the bends by
hand for shaping, and restore the
conduit.
In use, lift the hot head and vertically
straighten the steam conduit, and
shake the hot head.
Place the product on the ground.
·
Re-check whether the sealing
part is installed in place.
·
Please contact the professionals
for inspection and repair.
If the battery is powered off, replace
the battery.
Remote the transparent film from the
bottom of the controller.
After the power voltage is normal, it
can automatically restore heating.
GB
GB-12