ASROCK K7VM3 Manual Del Usuario página 8

2.4 Jumpers Setup 2.4 Jumpers Setup 2.4 Jumpers Setup
2.4 Jumpers Setup 2.4 Jumpers Setup
The illustration shows how jumpers are
setup. When the jumper cap is placed on
pins, the jumper is "SHORT". If no jumper cap
is placed on the pins, the jumper is "OPEN".
The illustration shows a 3-pin jumper whose
pin1 and pin2 are "SHORT" when jumper cap
is placed on these 2 pins.
Jumper
FSB_SEL1
(see p.2 item 8)
Note: The setting of the CPU front side bus frequency of this motherboard is by
means of the adjustment of jumper-setting. Please follow the figures above
to set the CPU front side bus frequency.
PS2_USB_PWR1
(see p.2 item 1)
Note: To select +5VSB, it requires 2 Amp and higher standby current provided by
power supply.
JR1
(see p.2 item 25)
JL1
(see p.2 item 24)
Note: If the jumpers JL1 and JR1 are short , both front panel and
rear panel audio connectors can work.
8 8 8 8 8
Setting
ASRock K7VM3 Motherboard
Short Open
Short pin2, pin3 to enable
+5VSB (standby) for PS/2 or
USB wake up events.