Installation
1 For installation, separate the BACK BOX.
PIPE-COVER
MOUNT PLATE
BOTTOM COVER
SCREWS
GASKET COVER
TOP COVER
2 Use the installation screws to secure the MOUNT PLATE to the installation
surface.
`
This product supports installation screw holes of SINGLE, 4" OCTAGON, DOUBLE, and SQUARE types.
3 Install the cable by passing it through the cable hole of the MOUNT PLATE
or pipe depending on the installation environment.
<for installation using a pipe>
<for installation on wall or ceiling>
4 Pass the network/power cables through the cable bushing.
`
When installing only the network cable, use the one-hole bushing provided as an accessory.
<when installing only network cable>
5 Insert the network/power cable bushing in the BOTTOM COVER.
6 Insert the provided bushing of audio/alarm cable in the BOTTOM COVER.
7 Assemble the MOUNT PLATE and BOTTOM COVER.
HEX
S3
8 Use the machine screws to join the camera body to the TOP COVER.
`
Separate the pipe cover
of the mount plate by
pressing its sides.
9 Use the severed section of the GASKET to insert the bushing into the camera
cable.
10 Fit the GASKET in the hole of the TOP COVER and assemble the GASKET COVER.
<when installing network/power cables>
11 Hang the safety cable of the TOP COVER on the triangular-shaped hook of
the BOTTOM COVER.
12 Connect the network/power/audio/alarm cables.
13 Once these are connected, join the camera body to the BOTTOM COVER.
SCREW(M5xL14.5)
GASKET
GASKET COVER
HEX
S3
CAUTION:
Be ware of the
Rated Voltage and Polarity
of the power connection.
SCREW (M3 x L6)
PT01-005730A
