Infiniton CSTT-4550 Manual De Instrucciones página 19

C. Hoisting height of indoor unit
Please adjust the hoisting height of indoor unit to make the dimensions of
indoor unit under the ceiling as shown in right figure.
① When there is gap between indoor unit and panel, the condensation may
occur.
② Line of trim panel (see right figure)
a. Connect the joint of swinging baffle motor conductor (on the trim
panel).
b. If not connecting the joint, the swinging baffle will not action. Properly
connect the joint.
c. Confirm the conductor of swinging baffle motor is not clamped
between indoor unit and trim panel.
5. Installation of air return grating and cap
A. Install the air return grating
B. Install in reverse sequences to "Preparation of trim panel". While
C. Firstly hang the air inlet grating onto the panel and then separately connect the lead connectors of
swinging motor and control box on panel to related connectors of body.
D. Re-install the air inlet grating in reverse sequence to those when removing the air inlet grating;
E. Re-install the mounting cover plate.
① Fix the mounting cover plate rope onto the lug (see the right figure);
② Gently press the mounting cover plate in the panel.
No gap allowed
4.Installation of unit
Install in reverse sequences to "Preparation of trim
panel". While rotating the air return grating, it can be
installed in 4 directions. If necessary to adjust the
installation direction of air return grating or required by
the user, the installation direction can be changed.
① First loosen the
upper nut
Install the
② Adjust the
cover plate
lower nut
self-tapping
screw
15
Indoor unit
Panel
10～13
Indoor unit
Air guidance
clearance
Cool air leak
Panel
⑥
Location of indoor unit At trim plate
(Line indication diagram)
is different from actual state
When installing the air return
grating, do not wind in the
conductor of swinging baffle motor.
When installing
the cover plate,
mount 4 slide
fasteners into
related slots.