Reset Remote; Battery Replacement; Troubleshooting - Springs Window Fashions Levolor Manual De Instrucciones

Battery Replacement

4. Use the open and close buttons to move shade to
desired limit position.
5. Hold stop button for ~6 seconds to put remote in
programming mode.
6. Hold manual control button and press close button
on remote while still in programming mode to set
new limit.
7. Red LED turns off and shade jogs to confirm limit set.
To set the top travel limit, repeat steps 1-7 using the open
button instead of close.

RESET REMOTE

Removes any connections previously programmed between
the remote and any window coverings.
• Using a paper clip, BRIEFLY press the remote
reset button.
Previously paired window covering(s) will no longer operate
with this remote.
BATTERY REPLACEMENT
Replacing the batteries in the remote will not cause the loss
of any window covering programming, including GROUPS and
FAVORITE. The remote uses two Alkaline AAA batteries.
To replace the batteries in the remote:
1. Slide open back of battery compartment.
2. Gently lift and remove the old batteries. To remove
batteries use a small screwdriver or fingernail to lift
battery and remove from slot.
3. Insert new batteries, be sure to align correct positive
and negative ends and press into place.
4. Align and replace the back cover onto the backside
of the remote.
NOTE: When the window covering starts moving slowly,
the batteries in the window covering battery pack may
need to be replaced. More than likely the batteries in the
remote are just fine.
12
Remote Control Guide

Troubleshooting

Problem Window covering does not operate with the
remote control.
Solution Make sure the Indicator light on the remote
control comes on when you try to operate
the window shading. If the Indicator light
does not come on, replace the batteries in
your remote control.
NOTE: The window covering can still operate
using the manual control button on the
headrail. If the window covering doesn't
operate with the manual control button,
make sure it has power. If the window
covering does not have power replace the
batteries on the standard battery pack or
the satellite battery pack.
Problem The window covering does not open or
close fully or has an intermediate stop
that is no longer wanted.
Solution Make sure the operation of the window
covering is not obstructed. Reset the
shading as described in "RESET WINDOW
COVERING PROGRAMMING" on page 11.
Troubleshooting
13
Remote Control Guide