Tabla de contenido
Idiomas disponibles
Idiomas disponibles
1e. Remove fascia
using a plastic trim panel tool, gently remove the plastic fascia
starting at the wheel wells first.
3. Hitch installation – raise hitch and bumper beam into position
aligning holes with studs on the end panel. Sandwich the hitch
between bumper beam and end panel.
©2016 Cequent™ Performance Products, Inc. -
Printed in Mexico
2. Remove bumper beam – using a 13mm socket with extension,
remove (6) flange nuts attaching bumper beam to end panel.
4. Reinstall fasteners - Loosely reinstall the existing (6) flange nuts
onto studs in end panel, (3) per side.
Sheet 5 of 18
24941NP
3-30-16
Rev. A
Tabla de contenido
