Telstar TCF015930DF Manual De Instrucciones página 12

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

There are two kinds of LCD display circuit board , LCD display show on "TIMER",
other, LCD show on "CLOCK",
"TIMER" and "CLOCK")
----If there is no any keystrokes, backlight will went out after 15 s ; At this point press the two buttons (which in
the middle) can start the backlight, at this time without any keystrokes, backlight will went out after 15 s.
---- ON/OFF button, the machine into the working state, heat pipe working (chip timing starts), indicator (red),
backlight, 12 minutes later, the red light is blinking (/ per second), backlight long bright until two hours later, the
machine stops working, lights go out, go into standby mode. At this time without any keystrokes, backlight go
out, clock continue timing
---- The working status press the other three buttons have not any effect;
---- The working status, press the ON/OFF button again, the machine stops working, light is extinguished, enter
standby mode.
---- Standby mode, if there is no any button operation, backlight will went out after 15 s, clock continue to tim-
ing. (at this point in the middle of two buttons can activate the backlight; at this time, press the ON/OFF button,
the machine into the working state; at this time press "prog", then into the CLOCK (CLOCK) set)
SET THE CLOCK (CLOCK)
1. In standby mode, press "prog" key once - "CLOCK" on the LCD blink (/ per second), at the same time on
the CLOCK ":" stop flashing (if not press any key within 15 s, confirmed that the current operation, automatic
return to the standby mode).
2. Press the "HOUR" button, adjust the HOUR - long press 1 seconds can be quickly adjusted.(according to
the clock in order to adjust: from 12:00 AM until to AM 1:00, AM...
3. Press the "MIN" , adjust the minutes - long press 1 seconds can be quickly adjusted. (such as: 00, 01, 02, 59,
00, 01...). ; - press the "MIN" key can adjust minutes, does not adjust the clock to 00 after transferred to 00.
4. After time setting, press "prog" or "ON/OFF" key to confirm and return to the standby mode (if not press
any key within 15 s, confirmed that the current operation, automatic return to the standby mode).
is can replace each other, so the following instructions will be use
12
Coffee Maker
TCF015930DF
is can replace each
Tabla de contenido
loading

Tabla de contenido