Important Safety Instructions - GE 898693 Manual Del Usuario

IMPORTANT SAFETY INSTRUCTIONS

When using an iron, basic precautions should always be followed, including the
following:
rEAd All insTruCTions bEforE usinG
• Only use an iron for its intended use
• To avoid the risk of electric shock, do not immerse the iron in water or other liquids.
• Always turn the iron to off before plugging or unplugging the iron from the
electrical outlet. Never pull on the cord to disconnect the iron from the electrical
outlet; instead, grasp the plug and pull on the plug to disconnect the iron.
• Do not let the cord touch hot surfaces. Let the iron cool completely before putting
the iron away. Coil the cord loosely around the iron when storing.
• Always disconnect the iron from the electrical outlet before filling the iron with
water, emptying the water from the iron, and when the iron is not in use.
• Do not operate the iron with a damaged cord or in the event the iron has been
dropped or damaged or there are visible signs of damage or it is leaking. To
avoid the risk of electric shock, do not disassemble the iron. Take it to a qualified
serviceman for examination and repair. Incorrect assembly might result in a risk of
electric shock when the iron is used after reassembly.
• The iron must be used and rested on a stable surface.
• When placing the iron on its heel, ensure that the surface on which the iron is
placed is stable.
• Close supervision is required for any appliance used by or near children. Do not
leave the iron unattended while the iron is connected or on an ironing board.
• Burns can occur from touching hot metal parts, hot water, or steam. Use caution
when you turn a steam iron upside down—there might be hot water in the reservoir.
• To avoid a circuit overload, do not operate an iron on the same circuit with another
high-wattage appliance.
• If an extension cord is absolutely necessary, a cord with an ampere rating equal to
or greater than the maximum rating of the iron shall be used. A cord rated for less
amperage can result in a risk of fire or electric shock due to overheating. Care shall
be taken to arrange the cord so that it cannot be pulled or be tripped over.
SAvE ThESE INSTRUCTIONS!
898693-Iron-EN-04.indd 2
2 2
2/9/12 4:58 PM