Tabla de contenido
Idiomas disponibles
Idiomas disponibles
07591
REF.
ACCESSORIES
3 mm
Hair comb
LEAF ALIGNMENT
- This appliance has been rigorously inspected to ensure that the blades
were greased and aligned before leaving our factory.
- Sheets must be realigned if they have been removed for cleaning and
replacement.
- To realign the blades, simply match the top and bottom teeth of the
blades up, point by point. (The end of the blade teeth should be
approximately 1.2mm from the bottom of the blade. Compare the blade
blades with the drawing.)
- If the blade alignment is incorrect, add a few drops of oil to the blades,
turn on the appliance for a few moments, turn off and unplug. Slightly
loosen the screws and adjust. Tighten the screws after correct align-
ment of the blade.
OIL
- To keep your hair clipper in perfect condition, the blades should be
greased every few haircuts.
- Do not use hair oil, grease, chemicals or abrasives. Any product not
specific to the device can damage it and even spoil it.
BLADE LEVER
- The lever is located near the thumb (if it is right-handed) so that it can
be easily adjusted while the hair clipper is in your hand.
- The lever adds versatility to your hair clipper by allowing you to
gradually change the closeness of your cut without an accessory comb.
- When the lever is in the highest position, the blades will give you the
INSTRUÇÕES IMPORTANTES DE SEGURANÇA / IMPORTANT SAFETY INSTRUCTIONS
6 mm
9 mm
INSTRUCCIONES IMPORTANTES DE SEGURIDAD
12 mm
Cleaning brush
Lubricant
Cutting shears
Tabla de contenido
