Function Setting; Timer Setting; Fan Speed Setting; Power Setting - Mestra 100512 Manual De Instrucciones

Installation of the filters
Take off right side cover.
Take out HEPA, activated carbon + photo catalyst filter,
and tear off its PE bag. Please install filters sequentially.
UV lamp replacing
Photo sensor is built-in the device, if the UV light is very
weak or not lighted, the UV icon on the product operating
panel will be flashing; it means UV lamp should be
replaced:
1. Take off the filter cover, and take out all filters. then
UV lamp can be replaced.
2. Hold the UV lamp and rotate it for 90 clockwise or
anticlockwise, then take it out.
3. Hold the UV lamp and rotate it for 90 clockwise or
anticlockwise, then install it well.

Power setting

Press the "POWER" icon on the product operating panel,
machine is entered the initial working status.
10
Take off right side cover
Install activated carbon
+ photo catalyst filter
Install HEPA

Function setting

Press the "Settings" icon on the product operating panel.
The anions, UV lamp and ozone can be chosen
individually or together.
Anions
UV lamp
Ozone (optional function)
Attention: Keep away from the room when ozone is
working.

Timer setting

Long press "Timer" icon. The timing mode will start.
Press "Timer" icon several times. You can choose a time
from 0 to 12 hours. The function will start after 5 seconds.
Remarks:
(1) Press "Timer" button to preview time set.
(2) Keep pressing "Timer" button if you want to cancel
time setting.
(3) When time setting is finished, the unit turns to
normal working mode.

Fan speed setting

If the unit is set as intelligent mode, the fan speed can't
be adjusted.
Press the "Fan Speed" button to select the fan speed:
HIGH - MIDDLE - LOW
If you keep pressing it for 3 seconds, you will start the
sleep mode. Press any icon to cancel.