albatros DIGIT ACDPL-S Manual De Uso página 8

Operating Instructions
If desired, the lymph drainage can be set to
remain localized on a particular part of the body by
pressing the same key twice in rapid succession.
The key surround will begin to fl ash, the colour
depending on the level selected at the time.
To resume cyclical operation of the lymph
drainage function, again press the key twice in
rapid succession.
To switch off the LYMPH DRAINAGE function,
press the key and hold down for about 1
second.
When the LYMPH DRAINAGE function is in
operation, the CYCLICAL MASSAGE option
cannot be selected.
Blue = maximum cycle speed: 5 sec.
Green = medium cycle speed: 8 sec.
Turquoise = minimum cycle speed: 12 sec.
Level of water in the tub (LED 1):
Led 1
When the level of water is not suffi cient for
operation of the hydromassage system, the light
is RED. When the level necessary for operation
of the system is reached, this light turns GREEN
and remains GREEN for the entire hydromassage
cycle.
Level of disinfectant in the tank (LED 2):
Led 2
This LED lights RED when the disinfectant tank
is empty, and GREEN when the tank is full.
Operation:
3
When the tub is switched on, only the two level
indicator LEDs (L1 and L2) will be lit.
Here is an example of how to operate the
system.
First, fi ll the tub with lukewarm water.
To switch on the WHIRLPOOL and LYMPH
DRAINAGE functions at medium speed,
proceed as follows: press and hold down the
WHIRLPOOL key; then press and hold down
the LYMPH DRAINAGE key. The function will
start at maximum speed. Press the LYMPH
DRAINAGE key again to select medium speed:
the key surround will light green.
20'
Timer
The hydromassage tub is fi tted with a timer
which automatically interrupts operation of the
hydromassage system after 20 minutes.
Manuale Uso VS DIGIT - Code 10009716 - Edition 1 - 01/2006
Filling the disinfectant reservoir
4
To fi ll the disinfectant reservoir, remove the fi ller
cap located on the edge of the tub, and introduce
1 litre of disinfectant (pilot light L2 on the keyboard
will change from red to green).
Led 2
Each disinfection cycle requires approximately
70 g of disinfectant solution (this quantity cannot
be modifi ed). The capacity of the reservoir is
therefore suffi cient for about 12 disinfection
cycles.
A level sensor inside the reservoir checks for the
presence of disinfectant; if the reservoir is empty,
the disinfection cycle will not start.
The recommended disinfectant solution, which
is available through our authorized dealers and
Service Centres, not only sanitizes the appliance,
but also prevents fermentation and unpleasant
odours, and inhibits the formation of algae and
mildew.
Disinfection cycle
5
Tubs fi tted with this type of keyboard may feature
the System Clean or Professional disinfection
system.
Whichever of the two systems is featured, the
disinfection cycle is an essential function which
guarantees the maximum hygiene and correct
operation of the appliance, since it disinfects
those parts of the system that cannot be reached
during normal cleaning.
With the System Clean disinfection system, the
water used for the hydromassage can be used.
The cycle can only be started when the tub is
fi lled with water.
For the Professional disinfection cycle, the tub
must be empty, since this system uses water
directly from the domestic water supply, and
mixes the water with the disinfectant to fl ush the
hydromassage circuit.
Important:
Before starting the disinfection cycle - whether
System Clean or Professional - ensure that the
tub is not in use.
Also ensure that all the hydromassage nozzles
are open.
The disinfection cycle lasts for about two minutes
and, once started, cannot be
Starting the disinfection cycle
Before starting the disinfection cycle, ensure
that:
1) The main power switch is set to "ON".
2) For System Clean disinfection, the level of
Led 1
2
interrupted.
water in the tub must be 5 cm above the
hydromassage nozzles (pilot light L1 on the
keyboard lights GREEN).
English