Programming In Auto Mode - Tamerica TPI-4900E Manual De Usuario

Programming in Auto Mode

This program is used to store up to 99 projects into the memory bank by doing the following:
1. Press MEMORY or the value next to it then enter the number from 1-99.
2. Enter your cut sizes for each step. In this example, we entered 6 values: 14.50; 11.00; 7.50;
5.00; 3.50 and 2.00. Do this by pressing EDIT then press 1 for the first value, enter 14.50,
then press OK. Repeat the process until the last value is entered then press EDIT again to
save the entries.
3. Once you are ready to proceed, press RUN to make the back gauge adjust to the first size then
press the 2 cut buttons simultaneously to operate the blade letting go only after both the
blade and the clamp have retracted after the cut cycle.
4. To erase saved values, repeat the above steps but enter 0.00 for each value.
NOTE: You may enter as many as 96 different cut sizes for each project. Use the left or right ar-
row keys to quickly scroll through the different cut sizes.
Align documents here
- 9 -
Press 2 cut buttons simultaneously