Changing The Nameplate - Smartwares DIC-222 Manual De Instrucciones

INSTALLATION
When installing the outdoor unit, make sure that the location you wish to install it is dry. It is important
that the camera or the electronics do not get wet.
1. Drill holes in the wall, insert the wall plugs in the holes. Place
2. Connect the wires (see WIRING).
3. Mount the outdoor unit on the bracket. Make sure it is
4. Use the special security screw on the bottom of the unit, to
5. It is possible to change the camera angle. Remove the unit

Changing the nameplate

To change the nameplate on the outdoor unit, please push on the
call button on one side, then use a flat screwdriver on the other
side to gently pull out the button. Now place the nameplate, and
replace the call button by pushing it back in.
6
the bracket and tighten the screws.
properly secured.
prevent theft.
from the bracket. Loosen the screw at the back of the device
(right behind the camera), change the angle and tighten the
screw again.
EN
INSTALLATION
1. Mark the installation location
2. Drill a hole in the wall, insert wall plugs and
screw unit onto wall.
3. Open the panel by the arrow direction
4. Pull the wires from the hole
EN
7