Fan Assembly; Motor Housing Assembly - Craftmade PFC52 Guia De Instalacion

7. Fan Assembly.

Remove motor assembly from temporary
hanging slot in hanging bracket. Carefully
push wiring and wire connectors into
outlet box. Slide one end of bar on motor
assembly through one of the openings in
the hanging bracket. Lift the other end of
the and slide it through opposite opening
on hanging bracket. Align holes in top of
motor assembly with holes in hanging
bracket. Secure motor assembly to
hanging bracket with lock washers and
motor mounting screws that were
previously removed (Section 5, page 4).

8. Motor Housing Assembly.

Temporarily hold motor housing up to
hanging bracket to determine which
2 screws align with slotted holes on top
rim of motor housing. Put motor housing
down and partially loosen the 2 screws in
the hanging bracket that correspond to
slotted holes in motor housing. Remove
the other 2 screws from the hanging
bracket.
Raise motor housing to hanging bracket
again, allowing slotted holes in motor
housing to align with loosened screws in
hanging bracket. Twist motor housing to
lock. Re-install the 2 screws that were
previously removed and then tighten all
screws to secure motor housing.
hanging
bracket
opening
motor
mounting
screws and
lock washers
motor
housing
screws
page 5
motor assembly
hanging
bracket
opening
slot
motor
mounting
screws and
lock washers
hanging
bracket
motor
housing
screws
motor
housing