LITTLE
WONDER
TRImmER
INTROdUCTION
On behalf of everyone at Little Wonder, we would like to
thank you for your purchase of a Little Wonder Gasoline
Powered Hedge Trimmer. This professional trimming
machine was designed to the highest standards to ensure
you many hours of uninterrupted service.
This manual provides the information necessary for safe
and efficient operation and service. For your safety, it
is critically important that you read and understand this
entire manual before operating your hedge trimmer.
Weight Specifications
Model
Single Edge
Weight, Dry
SERvICE INFORMATION
Cutter Bar
Contact your local Little Wonder dealer.
Engine
Contact an authorized Echo dealer. Dealers are listed in
the Yellow Pages under "Lawn and Garden Equipment
Supplies", "Lawn Maintenance" or "Lawn Mowers".
SPECIAL SAFETy INFORMATION
To reduce the potential for accidents, com-
ply with the safety instructions in this manual.
Failure to comply may result in serious personal
injury and or equipment and property damage.
Improper use or care of this trimmer, or
failure to wear proper protection can result
in serious injury.
Read and understand the rules for safe
operation and all instructions in this manual.
Wear hearing protection.
2230S
x
12.25 lb
SAFETy dECALS
An important part of the safety system incorporated in
this trimmer are the warning and information decals
found on various parts of the trimmer. These decals
must be replaced in time due to abrasion, etc. It is your
responsibility to replace the decals when they become
hard to read. The location of these decals and their part
numbers for ordering are shown on the following page.
GENERAL SAFETy RULES
1. THIS MACHINE CAN CAUSE SERIOUS INJURIES.
Read the instructions carefully for the correct handling,
preparation, maintenance, starting and stopping of the
machine. Be familiar with all controls and the proper
use of the machine. Pay particular attention to all
sections regarding safety.
Warning
Cutting hazard! Keep
both hands on handles
and away from blades!
2. Always keep a firm grip on both handles while the
blades are moving and/or the engine is running. On
single edge units the right hand grasps the front side
handle and the left hand grasps the rear handle. BE
AWARE!! The blades coast after throttle trigger is
released or engine is switched off. Make sure blades
have come to a complete stop and engine is off before
releasing a handle.
3. Maintain a firm footing and good balance, do not over-
reach while trimming. Before you start to trim, check
the work area for obstacles that might cause you to
lose your footing, balance or control of the machine.
While operating the machine always be sure of a safe
and secure operating position especially when using
steps or a ladder.
4. Keep area clear of children, pets, and bystanders.
5. Blades coast after throttle trigger is released or engine
is switched off.
SAFETy
Wear eye and
ear protection
Read and understand
owner's manual before
using! Keep in safe place!
5