Tabla de contenido
Idiomas disponibles
Idiomas disponibles
12. SEAMLESS LOOP.
- CREATE A LOOP
While a track is playing, press IN button to program the starting point of the loop.
And then press the OUT button to program the endpoint of the loop. The seamless
loop starts playing at once. While the loop is playing, you can press the OUT
button again to exit the loop.
Fig.1
Fig.2
- PROGRAM A LOOP.
A.If a SEAMLESS LOOP has already been created, press RELOOP BUTTON to
reenter the SEMALESS LOOP mode. Fig.5
B.Next, press OUT BUTTON to return to normal play. This disengages the
SEAMLESS LOOP mode. Fig.6
C. Press OUT button again for new desired ending point of the loop. Fig.7
D.To press and hold the RELOOP button until the end time of the loop is displayed
to edit a loop and the OUT button LED will light and flash turn the JOG
WHEEL to edit loop shooter or longer. Fig.8
Fig.5
Fig.6
13.TIME DISPLAY. During normal play, each time you press TIME button, the
display changes as following information of elapsed, remain and total remaining
time.
14. MEMORY CUEING (SETTING A CUE POINT). Press the MEMORY button to
make the unit enter cue memory mode (LED on), then press the desired BANK
button at the desired cue point to memorize. The corresponding CUE BANK
Button LED will flash then lit steadily to indicate the cue memory has been set.
To store BANK buttons, press the MEMORY button for 1 sec. and LCD will
indicate "SAVING".
15
All manuals and user guides at all-guides.com
GENERAL FUNCTIONS OVERVIEW
Fig.4
Fig.3
HOLD
Fig.7
Fig.8
15.RECALL CUE POINT . All the memorized cue points you can recall only by
pressing the desired bank button (LED on) you like.
The unit also can store all your programmed cue points and play mode (SGL,
TIME). These setting may be recalled at any time, even when a disc has been
removed and loaded at a later time.
To recall the save memory on a specific disc:
(1) Be sure a CD is not loaded into the drive.
(2) Press the MEMORY BUTTON and the memory LED begins to flash.
(3) Insert the CD. "RECALL" will display in the LCD while the memory is being
recalled and the corresponding CUE BANK LED will flash. While the recall
completed the MEMORY LED will turn off.
16. BACKUP. This will automatically keep your last setting (SGL, TIME) even if you
unplug AC current by pressing the MEMORY button for 1 sec.
17. MODIFYING EFFECTS PARAMETERS.
X PARAMETER. Press X button and LED on, you can turn the jog wheel to adjust
effect time(X) Parameter.
MOMENTARY PARAMETER MODIFICATION
PARAMETER
PERMANENT PARAMETER MODIFICATION
PARAMETER
DISPLAY
TIME VALUE OF PARAMETER
Y PARAMETER. Press Y button and LED on, you can turn the jog wheel to adjust
effect ratio(Y) Parameter.
MOMENTARY PARAMETER MODIFICATION
PERMANENT PARAMETER MODIFICATION
DISPLAY
RATIO VALUE OF PARAMETER
25
25
Fig.9
PARAMETER
25
PARAMETER
25
Fig.10
Tabla de contenido
