Brigmton W-908 Manual De Instrucciones página 16

USING THE CD/MP3
LOADING A DISC
1. Set the FUNCTION switch to CD/MP3 position.
2. Open the CD door.
3. Place an audio CD into the tray with the label side facing up.
4. Close the CD door.
The total number of tracks will appear on the display after several seconds.
5. To remove the CD, lifting CD door up to open CD compartment lid, grasp the CD by its edges,
and carefully take it out.
Note:
To ensure good system performance; wait until the disc tray completely reads the disc
before proceeding.
If no disc is loaded into the compartment, or the disc is placed upside down, the display will
show N0D.
PLAYING A DISC
1. Press the PLAY/PAUSE button to start playback.
The playback starts from track 1, the "
To interrupt playback, press the PLAY/PAUSE button. The "
track will flash on the display.
To resume playback, press the PLAY/PAUSE button again.
2. To stop playback, press the STOP button, the total number of tracks appears on the display.
SELECTING A DESIRED TRACK/PASSAGE
To select a desired track
Press the CD SKIP/SEARCH FORWARD/BACKWARD button repeatedly in stop mode or
during play until the desired track appears on the display.
Press the PLAY/PAUSE button to start play.
To search for a particular passage during playback (track scanning at high
speed)
Press and hold the CD SKIP/SEARCH FORWARD/BACKWARD button to scan the current
playing track at high speed until desired point passage, and then release the button.
Playback will start again from this point.
PROGRAM TRACKS
Programming tracks of disc are possible when playback is stopped. Up to CD 20 tracks /MP3 99
tracks can be stored in the memory in any order.
1. In stop mode, press the PROG./P-MODE button, the PROG will flash and the
will be on.
2. Press the CD SKIP/SEARCH FORWARD button to select the first desired track to be
programmed.
3. Press the PROG./P-MODE button to enter. The display changes to show
4. Repeat steps 2 & 3 to store other desired tracks until all tracks are programmed.
5. Press the PLAY/PAUSE button to start playback from the first programmed track.
6. Press the STOP button to stop program playback.
To Erase the Memory (Program)
To clear the program, you have two options:
1. Press the STOP button when the disc is stopped, or
2. Open the CD compartment lid, program will be erased.
All manuals and user guides at all-guides.com
" indicator is shown on the display.
15
" indicator and the current
P01
indicator
P02
.