Tabla de contenido
1. Power on the device and connect the USB cable to your computer.
2. Allow the gateway to boot up. This might take up to 30 seconds.
3. Your computer's OS should detect the USB device and install the drivers for the virtual NDIS network
adapter. The IP address is set automatically via DCHP.
4. Use a Web browser to go to address
5. Use login information shown in image A when prompted for authentication.
6. After logging in pay attention to the Signal Strength indication displayed in the Mobile widget (image B). To
maximize the cellular performance try adjusting the antennas or changing the location of your device to achieve the
best signal conditions.
A.
RF technologies
Max RF power
Power
GSM/WCDMA/LTE antenna
*Order code dependent.
**Higher gain antenna can be connected to compensate for cable attenuation when a cable is used. The user is responsible for the compliance with the legal regulations.
DEVICE CONFIGURATION
http://192.168.2.1
admin
Password*
TECHNICAL INFORMATION
Radio specifications
GSM, GPRS, EDGE, UMTS/HSPA+, LTE
33 dBm@GSM. 24 dBm@WCDMA. 23 dBm@LTE
Bundled antenna specifications*
AC/DC power adapter 9 V, 0.5 A, 4 pin plug
698-868/1850-2690 MHz, 50 Ω, VSWR < 2, gain** 2 dBi, omnidirectional, SMA male connector
B.
Data connection
State
SIM card slot in use
Bytes received/sent
-65 dBm
Connected
Registered (home); OPERATOR; 4G (LTE)
348.7 KB / 223.5 KB
Ready
Tabla de contenido
