Fan Assembly. Pgs - Craftmade South Beach SB52 Guia De Instalacion

5. Fan Assembly.
Remove hanging ball from downrod provided by
loosening set screw on hanging ball. Lower
hanging ball and remove stop pin and then slide
hanging ball off of the downrod. [Refer to
diagram 1.]
Loosen yoke set screws and nuts at top of motor
housing. Remove pin and clip from motor housing
yoke. [Refer to diagram 2.]
Tip: To prepare for threading electrical wires
through downrod, apply a small piece of electrical
tape to the ends of the electrical wires--this will
keep the wires together when threading them
through the downrod. [Refer to diagram 2.]
Determine the length of downrod you wish to use.
Thread safety cable and electrical wires through
threaded end of downrod and pull extra wire slack
from the upper end of the downrod. [Refer to
diagram 2.]
Thread downrod into the motor housing yoke until
holes for pin and clip in downrod align with holes
in yoke--make sure wires do not get twisted.
Re-insert pin and clip that were previously
removed. Tighten yoke set screws and nuts
securely. [Refer to diagram 2.]
Locate canopy cover and anti-sway adapter in
hardware pack. Slide yoke cover, canopy cover,
anti-sway adapter and canopy over downrod.
[Refer to diagram 3.] (Note: Canopy cover must be
turned with shiny side toward motor housing. If
using the anti-sway adapter, it must be turned with
flat side toward the canopy.)
["Fan Assembly" continued on next page.]
NOTE: The important safety precautions and instructions
appearing in the manual are not meant to cover all possible
conditions and situations that may occur. It must be
understood that common sense and caution are necessary
factors in the installation and operation of this fan.
set screw
diagram 1
electrical wiring
diagram 2
canopy
diagram 3
page 4
stop pin
hanging ball
safety cable
yoke set
downrod
screw
and nut
clip
downrod
canopy cover
yoke cover
pin
anti-sway
adapter
motor
housing