How To Wire Your Ceiling Fan; How To Install Your Canopy Housing - Fanimation XENO FP6729 Serie Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

1. Connect the green grounding lead from the ceiling

bracket to the supply grounding, from motor and from

wall control conductor (this may be a bare wire or wire

with green colored insulation). Securely connect wires

with a wire connector. Securely connect the white

wire (coming from motor) to the white supply (neutral)

wire using a wire connector. Securely connect the

black wire (coming from motor) to the black wire from

wall control using a wire connector. Securely connect

the blue wire (coming from motor) to the blue wire

from wall control using a wire connector. (Figure 1)

After splicing and making the wire connections, the

wires should be spread apart and turned upward with

the grounded conductor and the equipment-grounding

conductor on one side of the ceiling bracket and the

ungrounded conductor on the other side of the ceiling

bracket.

(Figure 1)

NOTE: This step is applicable after the neccessary wiring

is completed.

1. Remove one of the two shoulder screws in the

hanger bracket. Loosen the second shoulder screw

without fully removing it. Assemble canopy by

rotating key slot in canopy over shoulder screw in

hanger bracket. Tighten shoulder screw. Fully

assemble and tighten second shoulder screw that

was previously removed. (Figure 1)

To avoid possible fire or shock, make sure that the

electrical wires are completely inside the canopy

housing and not pinched between the housing and the

ceiling.

2. Securely attach and tighten the canopy screw cover

over the shoulder screws in the hanger bracket utilizing

the keyslot twist-lock feature. (Figure 2)