Idiomas disponibles
Idiomas disponibles
Step 3: Place the table rim (A, without tiles) upside down on a flat, non
abrasive surface to avoid scratching the rim. Attach the table leg frame
(from Step 2) using a bolt (E) and washer (G), guide this into the pre-drill
hole already in place in the table rim. Repeat on the other 3 legs and
table top support. Hand tighten only, some adjustment may be
necessary to ensure table legs are aligned properly. Once you have legs
and table top supports in the correct position, use the hex bolt driver (I)
provided to tighten all bolts. Each bolt must be tightened a few
revolutions at a time. In order to apply even pressure, we recommend
working in a cross corner ("X") fashion. Do not over tighten. Cover all
bolts with plastic covers (H).
Step 4: With the help of another person, turn the table in the upright
position. CAREFULLY place the tiles inside the rim.
IF YOU HAVE QUESTIONS OR CONCERNS, PLEASE CALL BOND TOLL FREE # 1-866-711-BOND (2663)
OR TO BETTER EXPEDITE YOUR REQUEST FEEL FREE TO EMAIL US
OR VISIT OUR WEBSITE UNDER CUSTOMER SERVICE SUPPORT
BOND MANUFACTURING CO.
1700 West 4
th
www.bondmfg.com
Street, Antioch, CA 94509
Page 3
