Scubapro AIR2 - 5 Manual Del Usuario página 3

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 17
!
WARNING
If a SCUBA is configured for and used by more than one diver at the same time, then it
shall not be used at depths greater than 30 meters and in water temperature less than
4°C if marked "EN250A", and less than 10°C If marked with "EN250A>10°C".
3.
IMPORTANT WARNING REMINDERS
For your protection while using SCUBAPRO life support equipment, we call your attention to
the following:
1. Use the equipment according to the instructions contained in this manual and only after
having completely read and understood all instructions and warnings.
2. Use of the equipment is limited to the uses described in this manual or for applications
approved in writing by SCUBAPRO.
3. Cylinders must only be filled with atmospheric compressed air, according to the EN 12021
norm. Should moisture be present in the cylinder, beside causing corrosion of the cylinder,
it may cause freezing and subsequent malfunction of the regulator during dives carried
out in low temperature conditions (lower than 10°C (50°F)). Cylinders must be transported
according to local rules provided for the transport of dangerous goods. Cylinder use is
subjected to the laws regulating the use of gases and compressed air.
4. A SCUBAPRO regulator must be overhauled by an authorized SCUBAPRO technician
every 2 years. The servicing overhaul is compulsory to preserve the limited lifetime
warranty. SCUBAPRO also recommends that highly used regulators (100 dives/year +)
undergo an inspection every 6 months and an overhaul every year.
Overhauls must be documented. When making repairs and during maintenance, only
SCUBAPRO replacement parts must be used.
5. Should the equipment be serviced or repaired without complying with procedures approved
by SCUBAPRO or by untrained personnel or not certified by SCUBAPRO, or should it be
used in ways and for purposes other than specifically designated, liability for the correct and
safe function of the equipment transfers to the owner/user.
6. The content of this manual is based upon the latest information available at the time of
going to print. SCUBAPRO reserves the right to make changes at any time.
7. Breathing must be continuous, without holding one's breath.
8. All dives must be planned and carried out so that at the end of the dive the diver will still
have a reasonable reserve of air for emergency use. The suggested amount is usually
50 bars (725 psi).
SCUBAPRO refuses all responsibility for damages caused by non-compliance with the
instructions contained in this manual. These instructions do not extend the warranty or the
responsibilities stated by SCUBAPRO terms of sales and delivery.
In order to maintain the warranty, maintenance must be performed by a qualified SCUBAPRO
technician, and maintenance records must be kept. For details, contact an authorized
SCUBAPRO dealer.
!
WARNING
Don't connect your AIR2 to the upper central LP port in the first stages equipped with
turret since the axial-direct High Flow could make your AIR2 not work properly.
3
Tabla de contenido
loading

Tabla de contenido