Tripp-Lite SNMPWEBCARD Manual De Instalación página 8

Installation
DO NOT MODIFY UNLESS DIRECTED BY TRIPP LITE
TECHNICAL SUPPORT
Default Ethernet setting (0=Auto, 1=10 Half, 2=10 Full, 3=100 Half,
4=100 Full)?
DO NOT MODIFY UNLESS DIRECTED BY YOUR
ADMINISTRATOR
You can also change the root password, real-time clock and other settings.
(Tripp Lite recommends against changing the default settings unless you are
an advanced user with a specific purpose.) After you have finished entering
settings, the card will save changes to memory and reboot (this may take
several minutes). After the card reboots, the initialization page should
display the new static IP settings.
Remove Serial Cable: Using one hand to hold the card in place, remove the
3-7
serial cable. Proceed to 4 -Test and Configure.
4 - Test and Configure
Test Network Connection: After an IP address has been assigned to the
4-1
card, try to access it with a Web browser that supports frames, forms and
Java . Open a Web browser on a computer connected to the LAN and enter
™
the card's IP address. You should be prompted for a password. The user
name is admin and the default password is admin. After you enter the user
name and password, the PowerAlert Status page will appear in the browser
window. For more information about configuration and operation of the
managed device, refer to the SNMPWEBCARD User's Guide, included on
the CD-ROM bundled with the card.
Default UPS Shutdown Setting: During a loss of utility power, the
4-2
SNMPWEBCARD is configured to shut down the UPS system 2 minutes
after a low battery signal is received from the UPS. This allows the UPS to
provide the maximum available runtime to connected equipment. If you
want to change the default setting, follow these instructions:
200907010 93-2916.indb 8
[Auto]
8
10/8/2009 5:16:38 PM