Tabla de contenido
Idiomas disponibles
Idiomas disponibles
ASSEMBLY AND INSTALLATION:
INSTALLATION (Fig. 2)
5.
Place the wall plate [N] over the outlet box [O], making sure the fixture screws [G]
feed through the holes on the wall plate [N]. Adjust the fixture screws [G] until they
protrude out from the wall plate [N] 63 mm / 0.25 in / 0.25 po. Remove the wall plate
[N] and secure the position of the fixture screws [G] by tightening the hex nuts [E]
against the mounting bracket [D].
6.
Carefully tuck all wires [H-M] and wire nuts [C] into the outlet box [O]. Place the wall
plate [N] back onto the fixture screws [G], and secure it into place using the lock
nuts [B].
7.
After installing the fixture [A], caulk the upper 2/3s of the wall plate [N] to the
mounting surface. Leave the bottom 1/3 un-caulked to allow for drainage of any water
that might leak into the enclosure. The manufacturer recommends a non-drying
exterior caulking material. A good example is a clear silicone rubber sealant for
exterior use.
8.
Restore power at the circuit breaker. Turn on the wall switch.
Fig. 2
B
A
A. Fixture
B. Lock Nut
G. Fixture Screw
N. Wall Plate
O. Outlet Box
G
5
O
N
Tabla de contenido
