Springer BC-127 Manual Del Usuario E Instalación página 6

All manuals and user guides at all-guides.com
the back of the control panel.
part and then the upper part.
right hand side, but if you wish, it is possible to change it to the
other side. To do this, withdraw the plastic front, pass the cable to
the other side placing it in the lower part of the appliance, and clip
the plastic front on the labeled place.
on the place of installation, you may use a hose connected to the
drainage net of your residence to avoid water dripping from
occurring.
Drain
and condenser please verify that the lateral and superior openings
of the appliance are turn outward and TOTALLY cleared.
Otherwise, your appliance may present operation problems, with
possible compressor failure. Very thick walls should be beveled
outwardly.
WALL INSTALLATION USING SPECIAL CONCRETE BOXES
- follow all the previous instructions.
- verify if the slope of the appliance is correct (0,5 blister - 1 cm).
- leave lateral and upper openings so the air flow within the
compressor and the condenser is normal.
INSTALLATION ON WINDOWS
cases in which there is not any possibility of installing the appliance
- Put the plastic front back on by encasing first the lower
3) The unit comes out of factory with the cable arranged on
4) Your appliance has a drainage for water to exit. Depending
5) In order to keep a normal air flow through the compressor
The installation on windows is recommended only in those
6