Idiomas disponibles
Idiomas disponibles
SpECIFICaTIONS
Output: 12V DC – 10 A
(CAUTION: Do not exceed 10 Amps)
Input: 110-120V AC
50/60Hz 3.8A
SaFETY GUIDELINES
• Read all instructions before operating this converter. Place instructions where
they can be used for future operations.
• The converter will not shut off automatically. Turn off immediately after use.
• Although the converter has a fan, it will get warm with use. Do not place the
converter on flammable materials such as carpeting, upholstery or paper.
• Allow the converter to cool before storing.
• For indoor use only. Ensure the converter is always used or stored in a dry
environment.
• Do not put fingers into the 12V receptacle.
• Close supervision is necessary when used around infants, children or anyone
incapable of unplugging the converter.
• Do not use the converter to recharge batteries.
• Unplug the converter when not in use and before cleaning.
• Risk of electric shock, do not immerse the plug or converter in any liquid.
• Do not use the converter if it is wet.
• Do not use the converter with a damaged cord or plug, or if the converter has
been damaged in any way.
• Do not use the converter for anything other than its intended use.
• Do not open the converter.
mOUNTING INSTRUCTIONS
The converter can be permanently mounted to any flat surface.
Rotate outwards the two metal brackets on the underside of the converter
to expose the screw holes. Utilize these two brackets for mounting (screws
not included).
OpERaTING INSTRUCTIONS
1. Remove all cable ties and uncoil all of the cables before using the AC
to DC power converter.
2. Make sure the power switch of the converter is in the OFF position.
3. Plug the converter into a 110/120V AC standard wall outlet.
Note- The use of an extension cord is not recommended. If you require
the use of an extension cord only use a heavy duty 12 gauge cord less
than 50 feet (30.5 meters) long.
4. Insert the 12V DC accessory plug from the device being operated into
the converter's socket (maximum draw 10 amps or 120 watts). The 12V
socket is wired so the center conductor is positive (+) and the outer
sleeve is negative (-).
Note - Always confirm that the 12V plug on your chosen device is wired
the same way.
5. Place the converter power switch in the ON position. The Red "Power
On" LED will light.
6. Turn on the 12V device being operated.
7. To disconnect, reverse the procedure.
Note - Make sure to let the converter cool completely before storing.
TROUBLESHOOTING
If the device is not functioning:
Confirm that the converter's red "Power On" LED is lit. If not, check
to make sure the AC outlet is receiving power. If the AC outlet has no
power, check wall switches, breakers and fuses.
If the red LED is on and the device is not functioning:
A. Remove, clean and reinsert the device's 12V plug into the
converter's 12V socket to ensure a good connection.
B. Verify the device you are looking to use is working by plugging it
into a vehicle's 12V accessory port.
C. Check the device's fuse (either in the 12V plug or in the device).
If the red LED is on, but goes out when the device is plugged in:
The converter is overloaded. Check the device's power consumption
requirements.
WaRRaNTY
This product is covered by a one (1) year limited warranty. Sunforce
Products Inc. warrants to the original purchaser that this product is free
from defects in materials and workmanship for the period of one year
from date of purchase.
To obtain warranty service please contact Sunforce Products for further
instruction, at 1-888-478-6435 or email [email protected].
Proof of purchase including date, and an explanation of complaint is
required for warranty service.
