REMEMBER
• Our valves must be installed by professional installers
in accordance with current regulations and recommendations in your
country, and the specifications of the fluid engineer.
• Sizing the pipes correctly will avoid problems of flow rate, pressure
loss and water hammer (see calculation table in our brochure and online
at www.delabie.com).
• Protect the installation with filters, water hammer absorbers
and pressure reducers to reduce the frequency of maintenance
(recommended pressure from 1 to 5 bar maximum).
• Install stopcocks close to the valve to facilitate maintenance.
• The pipework, filters, non-return valves, stopcocks, bib taps, cartridge
and all sanitary fittings should be checked at least once a year, and more
frequently if necessary.
MAINTENANCE & CLEANING
• Cleaning chrome and stainless steel: do not use abrasive, chlorine
or any other acid-based cleaning products. Clean with mild soapy water
using a cloth or a sponge.
• Frost protection: drain the pipes and operate the valve several times
to drain any remaining water. In the event of prolonged exposure to frost,
we recommend taking the mechanisms apart and storing them indoors.
The installation guide is available on: www.delabie.co.uk
The installation guide is available on: www.delabie.com
After Sales Care Support:
18