Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Installation & Mounting:
Carefully remove the unit from its packaging. Examine the
unit for transit damage. If damage is found, return the product
to your local dealer for warranty replacement. Do not use
damaged or broken parts. Determine a mounting location that
ensures a clear line of sight for oncoming traffic.
!
Caution:
When drilling into any vehicle
surface, make sure that the area is free from any
electrical wires, fuel lines, vehicle upholstery, etc. that
could be damaged.
Mounting with Shroud:
FIGURE 1
MOUNTING WITH VHB TAPE:
1. Ensure that the light head is securely attached to the shroud.
2. Install rubber gasket onto the shroud.
3. Remove the suction cup from each shroud bracket.
4. Clean the brackets with supplied alcohol wipe.
* for extra adhesion, see notes below.
5 Remove one side of the adhesive liner & apply to both brackets. Apply light pressure
for 20 seconds.
6. Install the bracket as shown on Figures 4 & 5. Gently hand tighten the nut.
7. WITHOUT removing the second adhesive liner, hold the product to desired location.
Loosen & hand tighten the nut as needed to adjust the light head angle. Once
desired angle is achieved, gently tighten the fastener using a 10mm wrench or
socket.
8. Clean mounting surface with supplied alcohol wipe.
*for extra adhesion, see notes below.
9. Remove the second adhesive liner.
10. Apply product on to the treated surface. Apply light pressure for 20 seconds.
** MOUNTING HARDWARE NOT PROVIDED
FIGURE 3
*For extra adhesion, use 3M Tape Primer. For product & application information, go to: https://multimedia.3m.com/
mws/media/65952O/3mtm-tape-primer-94.pdf
!
into any vehicle with aftermarket tinted glass, it is best
practice to trim the film around the surface where
bracket will be mounted to ensure adhesion and avoid
damage to the tint film.
FIGURE 2
MOUNTING WITH SUCTION CUP:
1. Ensure that the light head is securely attached to the shroud.
2. Install the shroud bracket as shown on Figures 4 & 5. Gently hand tighten the nut.
3. Clean mounting surface with supplied alcohol wipe.
4. Apply the product on to the treated surface by gently pressing the suction cups on to
the glass. Apply light pressure for 20 seconds. Gently adjust the light head to its
desired angle if needed.
5 Once desired angle is achieved, gently tighten the fastener using a 10mm wrench
or socket.
MOUNTING WITH HARDWARE (NOT PROVIDED):
1. Ensure that the light head is securely attached to the shroud.
2. Install the shroud bracket as shown on Figures 4 & 5. Gently hand tighten the nut.
3. Clean mounting surface with supplied alcohol wipe.
4. Install product on to the treated surface by using #8 hardware screw (not included).
5. Gently adjust the light head to its desired angle if needed.
6. Once desired angle is achieved, gently tighten the fastener using a 10mm wrench
or socket.
Caution:
When installing using VHB tape
Page 2 of 6
Tabla de contenido
