Starting And Stopping; Starting Instructions - Remington RM4625 Manual Del Operador

WARNING:
Operate this unit only in a well-ventilated
outdoor area. Carbon monoxide exhaust fumes can be
lethal in a confined area.
WARNING:
Avoid accidentally starting the unit. To avoid
serious injury, the operator and the unit must be in a stable
position when pulling the starter rope (Fig. 6).
WARNING:
The tines may rotate during the starting
process. Always stand in the starting position. Use one
foot to hold the wheels in place. Tilt the unit back slightly
to bring the tines off the ground.

STARTING INSTRUCTIONS

1. Mix gasoline with oil. Refer to Oil and Fuel Mixing Instructions.
2. Fill the fuel tank. Refer to Fueling the Unit.
NOTE: There is no need to turn the unit on. The On/Off switch is in
the ON ( I ) position at all times (Fig. 4).
3. Slowly press and release the primer bulb 10 times (Fig. 5). If fuel
cannot be seen in the primer bulb, press and release the primer
bulb until fuel is visible.
4. Move the choke lever to Position 1 (Fig. 5).
5. Stand in the starting position (Fig. 6). Hold the handlebar and
squeeze the throttle control with one hand. Hold the starter rope
with the other hand. Use one foot to hold the wheels in place.
6. Tilt the unit back slightly to bring the tines off the ground (Fig. 6).
NOTE: SQUEEZE and HOLD the throttle control for ALL further steps.
7. Squeeze the throttle control (Fig. 4) and pull the starter rope with
a controlled and steady motion 5 times (Fig. 6).
8. Continue to squeeze the throttle control. Move the choke lever
to Position 2 (Fig. 5).
9. Continue to squeeze the throttle control. Pull the starter rope with
a controlled and steady motion 3 to 5 times to start the engine.
10. Continue to squeeze the throttle control. Allow the engine to
warm up for 30 to 60 seconds.
11. Continue to squeeze the throttle control. Move the choke lever
to Position 3 (Fig. 5) and continue warming the engine for an
additional 60 seconds. The unit may be used during this time.
NOTE: The engine is properly warmed up when it accelerates
without hesitation.
IF... the engine hesitates, return the choke lever to Position 2 (Fig. 5)
and continue the warm-up.
IF... the engine does not start, begin the starting procedure with step 3.
IF... the engine fails to start after a few attempts, move the choke
lever to Position 3 and squeeze the throttle control. Pull the
starter rope with a controlled and steady motion 3 to 8 times.
The engine should start. If it does not, repeat this instruction.
IF... the engine is already warm, begin the starting procedure with
step 8.
STOPPING INSTRUCTIONS
1. Release the throttle control and allow the engine to idle.
2. Press and hold the On/Off switch in the OFF (O) position until
the engine comes to a complete stop (Fig. 4).

STARTING AND STOPPING

Start/On (I)
Position 1
Position 2
Position 3
Starting Position
8
Stop/Off (O)
Fig. 4
Fig. 5
Starter Rope Grip
Fig. 6
Throttle Control
On/Off Switch
Choke Lever
Primer Bulb
Throttle
Control